Detailed Product Description
We are pleased to introduce ourselves as designer and manufacture of a unique revolutionary product CROWN TURBINE.
This unique product improves the working condition of the workplace are environmental friendly and also conserve the electric energy. The CROWN TURBINE also substitutes the energy in ventilation application and replace exhaust fans to ventilate sheds there by even earns carbon credits for the user organization.
The CROWN TURBINE is a revolutionary conceptual product which exhausts the hot gases from an enclosed area with out using any electric power. Yes absolute zero power consumption.
It has no operating cost and give excellent ventilation performance making the work area like boiler, furnace, oven sheds, curing and drying area, casting and moulding sheds, workshops, process area utility sheds, DG sheds, compressor houses, power house and packing area, go-down etc. more cooler and comfortable to work in.
A very important added advantage accomplished by the fall in temperature (which is induced by the enhanced cycles of air changes) is the improvement in the performance of the volumetric compression machines like air compressor, DG sets, turbine which give better performance with lower intake air temperature. Of course with improved air circulation and the better working condition even the human productivity and behavior improves positively.
The crown turbine are most cost effective substitute to exhaust fan which continuously gulp the electric power and also have maintenance problems. What is more advantageous that being a wind operated gadget it qualifies for 80% depreciation in the first year itself.
Advantage of Our Crown turbine air ventilator
No greasing and no oiling. So it is friction less, easy to rotate, no bearing is used, maintenance free, life long.
- By using FRP base, you will get more natural light inside the working area and you can switch off the light which are using in that area and thereby saving power consumption/electric bill.
- Easy to install, while installation of the ventilators, on existing sheet, cutting is not done. Only drawing/shifting of the existing is done. So that leakage of water may not be there. If required, any shifting of the ventilators in future to another spot, the same sheet can be replaced in the earlier position. FRP base length angle to angle (putting distance + 200mm extra over laping example: 1400+200 extra = 1600mm long std. with
- FRP base open suction area 1000mm x 600mm capacity. So cover maximum smoke, vapours and temperature inside workshop area making good atmosphere to work.